We used this one which i was estatic to find because it was about 5 per board.
Tongue and groove for barn doors.
Build the door as a blank and then cut it down on a table saw to make it fit the opening.
Lay all of your pine tongue and groove out.
I purchased mine at lowe s for 5 58 each and used 8 boards for the door 3 for the frame and 2 for the british brace arrow look so 13 total per door.
Trim the excess tongue and groove boards off using a circular saw.
10 pieces of tongue and groove pine 8 ft tall or however tall you want it it comes in 6 ft 8 ft and 12 ft at home depot.
Our door opening is 4 wide so we built ours to be 4 wide and 7 tall.
Start by building a door for a 36 inch opening with typical 4 by 96 inch tongue and groove wood.
Since i wanted my door to be 37 inches wide to cover the opening and my 6 pieces of 1x6 inch tongue and groove which really measures 75 x 5 5 inches only measures to 33 inches when assembled 5 5 x 6 33 my 7th tongue and groove board needs to be cut down the middle using a table saw to two 2 inch pieces.
I would purchase a few extra just in case you make a mistake.
Here is what we used to make our barn door.
Diy barn doors step 1 selecting the material.
The tongue and groove shiplap is the base of our door so we trimmed each of those planks to 7 tall.
I also like this board because it has.
With the right bracing a door made from tongue and groove wood is solid and will hold up over the years.
Materials for building a tongue and groove barn door.
My barn door will be using the 79 or 6 foot 7 inch kit from industrial by design that accommodates a maximum door opening size of 38 or smaller.